For the drying tank of the concrete mixer, there are users who do not care about it very much. That is a wrong idea. The drying tank still plays a great role in the use of equipment. Let's talk about the problem.
The drying tank of the concrete mixer is used to filter the water vapor in the compressed air of the air passage system and prevent the air storage cylinder and various pump valves from being corroded. Therefore, whether the drying tank of concrete mixer can work normally will directly affect the performance of brake. In reality, however, Dorka's friends tend to ignore dry POTS because they don't fully understand them.
The operation of replacing the dry tank of the cement mixer is not complicated. Check whether the bottom of the tank is wet or water with the vent valve at the bottom of the tank. If the drying tank fails, water will flow out after opening the valve, and a new drying tank should be replaced immediately.
So when will the drying tank of the concrete mixer be replaced? A lot of people probably don't switch every few years, as long as it's okay. Moreover, the service life of drying tanks of different brands is different, the climatic environment of vehicles is also different, and the replacement cycle is difficult to be unified.
If the concrete mixer driver really doesn't know when to replace it, he can tell by checking the gas tank for water. However, I also want to remind you that because the drying tank of the concrete mixer is connected with the gas road, there is a certain pressure difference between the tank and the outside world. When the compressed air is not empty, it can be hastily disassembled to release the compressed air instantly, which is convenient to use.
Therefore, before removing the drying tank, be sure to empty the air in the tank (repeatedly apply the brake until the barometer reads zero). After removing the drying tank with a special wrench, you can see water droplets on the base, indicating that the humidity of compressed air is still very high.
If the filtration of the drying tank is not good, liquid water will enter the pump valves of the brake through the air path. Before installing a new drying tank, clean the top of the base to prevent oil stains from entering the new tank and affecting the dehumidification performance. Then apply a layer of oil to the rubber gasket under the new drying tank to lubricate it and prevent damage to the rubber gasket during installation.
The drying tank of concrete mixer truck is an important factor that can not be ignored. If inferior products are used, or dehumidification performance decreases without replacement for a long time, performance braking of the whole vehicle will be seriously affected. Therefore, it is necessary to replace the drying tank of the concrete mixer truck on a regular basis, and you can always consult us at www.zkzdsljbc.com!